Brake Accessories
Mountin kit for Handbrake Cable, hydraulic system only, year thru 7/55
Regular price:
€19.90
Fit NOT cable brakes !!!
Mounting for Handbrake Cable at IRS Arm
Regular price:
€2.50
You have to install this single use clamp by using a rubber mallet. This clamp is missing from most cars.
Mounting kit for handbrake lever
Regular price:
€5.70
When changing the rear brake pads, the handbrake levers must also be removed and attached to the new brake shoes. Since the existing bolts and clips are often heavily rusted or worn out from repeated use, replacement is recommended. With our mounting kit you can easily replace both handbrake levers on the rear axle.
Axle Nut rear, year thru 07/67
Regular price:
€9.00
Perfect CNC machined with the correct hardness and a flat machined surface.
You cannot compare this with the cheap aftermarket nuts.
Axle Nut rear, year 08/67 on
Regular price:
€9.90
Perfect CNC machined with the correct hardness and a flat machined surface.
You cannot compare this with the cheap aftermarket nuts.
T-Piece for Brake Line
Regular price:
€8.00
Two connectors are required for vehicles with IRS and one connector is required for vehicles with a swing axle..
Brake Cable Bracket, right, year 10/57 on
Regular price:
€2.05
Fits left side year through 10/57 (through chassis # 1673410), fits right side year 10/57 on (starting at chassis # 1673411)
Brake Cable Bracket, left year 10/57 on
Regular price:
€2.05
Fits right side year through 10/57 (through chassis # 1673410), fits left side year 10/57 on (starting at chassis # 1673411)
Mounting kit for handbrake cable holder, from year 10/57 on
Regular price:
€1.11
This handbrake cable attachment kit is suitable for Beetles from October 1957. The set allows installation on the left or right side of the vehicle. Two sets are required.
Spacer, Master Cylinder to Bulkhead, not 1302/1303
Regular price:
€4.00
Replacing the master cylinder in your Beetle can be a real challenge, especially when letting the mounting spacers drop though your fingers.
If your invasive Beetle cavity search has yielded zero spacers, we’ve got you covered!
These important spacers install between the walls of your front cross panel, and prevent the walls from collapsing as you fasten the master cylinder into place.
Mounting kit master brake cylinder, year 54 on(not 1302/1303)
Regular price:
€9.50
With our attachment kit you not only get the right screws and spring washers, but also the sleeves for the Napoleon hat.
This attachment kit is suitable for all Beetles built after 1954 and fits both the sedan and the convertible.